Setting up your tv, Installing remote control batteries, Connecting an antenna or basic cable – Dynex DX-LCD37-09 User Manual

Page 8: Connecting a cable or satellite box

Advertising
background image

8

Setting up your TV

Setting up your TV

Installing remote control batteries

To install remote control batteries:

1 Open the battery compartment.

2 Insert two AA batteries into the battery compartment. Make sure

that the + and – symbols on the batteries match the + and –
symbols in the battery compartment.

3 Close the battery compartment.

Notes:
Make sure that you match the + and – symbols on the batteries with the

symbols in the battery compartment.

Do not mix different types of batteries or old and new batteries.
If you do not intend to use the remote control for a extended period of

time, remove the batteries to prevent leakage.

Do not try to recharge batteries non-rechargable batteries. They may

overheat and rupture.

Connecting an antenna or basic cable

To connect an antenna or basic cable (no cable box):

• Connect one end of a 75 ohm coaxial cable to the antenna or

basic cable wall jack, then connect the other end of the cable to
the ANT. IN jack on the back of your TV.

Notes:
Always unplug the coaxial cable when you move your TV.
If you use an antenna to receive analog TV, the antenna should also work

for digital TV (DTV).

If you want to switch between antenna and cable, install an antenna

selector.

If you need help connecting cable TV, contact your cable TV provider.

Connecting a cable or satellite box

Note: Installation methods may vary depending on the type of cable or

satellite box. Contact your cable or satellite provider for more
information.

To connect a cable or satellite box:

1 Connect a 75 ohm cable to cable or satellite TV wall jack, then

connect the other end to the Antenna IN jack on the cable or
satellite TV box.

2 Connect a 75 ohm coaxial cable to the RF OUT jack on the cable

or satellite TV box, then connect the other end to the ANT. IN
jack on the back of your TV.

#

Button

Description

17

CH / CH

Press to go to the next or previous
channel in the channel list, or to
select the external input mode.

When

you press one of these buttons
repeatedly, you cycle between:

• Analog TV channels in the

channel list

• Digital TV channels in the channel

list

• Video1
• Video2
• Component1
• Component2
• HDMI1
• HDMI2
• PC

Antenna

Cable

Coaxial cable

RF OUT

ANT. IN

Satellite

Cable TV

Cable or satellite box

Coaxial cable

Coaxial cable

Advertising