Palram SUNTU Rooflights - Manual (Page 3)

SUNTUF® Technical Guide
Profile: SUNTUF® 100
©PALRAM Industries. All rights reserved.
 Important Notes
 Use only PALRAM approved accessories, including EPDM rubber washers, silicones,
sealing tape, closure fixtures etc.
 For clear SUNTUF onto wooden purlins, apply white acrylic paint, or aluminum tape, in
order to prevent over-heating of the purlins.
Cutting Tips
 Use jigsaw or circular saw with fine tooth blades.
 Apply high blade speed with moderate feeding rate.
 Support the sheets near the cutting line.
 Clean the dust and cutting chips after cutting.
Fastening Tips
 Use adjustable electric screwdriver.
 The screw must be installed perpendicular to the SUNTUF sheet.
 Important: Do not over-tighten.
Safety
 Do not step directly on the panel.
 Use stepping boards.
 Work according to local safety regulations.
Handling and Storage
 Store in a dry shaded place, protect from direct sunlight and rain.
 Avoid covering the sheets with heat absorbing materials.
 Avoid contact or environment of chemicals.
 Protect the sheets from any physical damage.
Inasmuch as PALRAM Industries has no control over the use to which others may put the material, it does not guarantee that the same results as those
described herein will be obtained. Each user of the material should make his own tests to determine the material’s suitability for his own particular use.
Statements concerning possible or suggested uses of the materials described herein are not to be construed as constituting a license under any PALRAM
Industries patent covering such use or as recommendations for use of such materials in the infringement of any patent. PALRAM Industries or its
distributors cannot be held responsible for any losses incurred through incorrect installation of the material. In accordance with our company policy of
continual product development you are advised to check with your local PALRAM Industries supplier to ensure that you have obtained the most up to
date information.