ParkZone PKZ6375 - Manual (Page 10)

EN
The CG location is 73-83mm back from the leading edge of the wing. Install
the recommended fl ight battery with the end of the battery against the front
wall of the battery compartment. Make sure the fl ight battery is secured using
the hook and loop strap.
Aircraft CG and weight is based on a ParkZone 11.1V 2200mAh 25C battery
(PKZ1029) installed.
Center of Gravity (CG)
73–83mm
2.90–3.30
inches back
from the lead-
ing edge of the
wing.
NOTICE: DO NOT attempt to belly land your aircraft with the engine scoops
installed or damage to the aircraft may result.
1. For scale appearance, install the included engine scoops (A) under the
engine nacelles by using 2 screws (B).
Engine Scoop
1. Read this instruction manual thoroughly.
2. Remove and inspect the contents.
3. Charge the fl ight battery.
4. Fully assemble the model.
5. Install the fl ight battery in the aircraft (once it has been fully charged).
6. Bind the aircraft to your transmitter. 7. Make sure the linkages move freely.
8. Perform the Control Direction Test with the transmitter.
9. Adjust the fl ight controls and transmitter.
10. Perform a radio system Range Check.
11. Find a safe and open area.
12. Plan fl ight for fl ying fi eld conditions.
First Flight Preparation
B
A
10