ParkZone PKZ6375 - Manual (Page 6)

EN
1. Remove the tubes (A), inside struts with wheel collars (B) and screws (C)
from the fi xed left and right struts.
2. Install the wheels (D), inside struts with wheel collars, tubes, and screws
on the retract struts (E).
3. Install the included left and right retract struts in the optional retracts (F)
using the set screws (G).
4. Remove 3 screws (H), the fi xed landing gear cover (I), 4 screws (J) and the
fi xed gear mount (K) from each engine nacelle.
5. Install the retracts (L) in the wing using 8 screws (M) (4 per side) removed
from the fi xed gear mounts.
6. Connect two servo extensions (PKZ5403) (N) to the retract and push the
extension connectors through the channels in the wing and out the holes
used by the aileron connectors.
Tip: Ensure the extended landing gear wheels have no toe-in or toe-out for
proper ground handling.
7. Install the retract covers (O) on the nacelles by using the 6 screws from the
fi xed landing gear covers.
8. Connect the servo extension connectors to a Y-harness in the fuselage.
9. Connect the Y-harness to the GEAR channel of the receiver.
10. Do a control test of the retracts using your transmitter. During operation,
adjust parts so the retracts are not blocked. Tighten the screws in the
wheel collars, using threadlock when needed.
E-fl ite Retractable Landing Gear OPTIONAL (EFLG100,
sold separately
)
A B
C
D
E
Fixed Landing Gear
Retractable Landing Gear
We recommend installing the E-fl ite electric retracts (optional) in the wing
before installing the wing on the fuselage.
F
G
H
I
J
K
L
M
N
O
6