ParkZone PKZU2380 - Manual (Page 7)

7 EN
Installing the Flight Battery
1. Remove the magnetic canopy.
2. Install the battery all the way to the front of the
battery compartment.
3. Refer to the “Connecting the Battery and
Arming the ESC” section below.
4. Reinstall the canopy.
CAUTION: Always disconnect the Li-Po
battery from the aircraft receiver when not fl ying
to avoid over-discharging the battery. Batteries
discharged to a voltage lower than the lowest
approved voltage may become damaged, resulting
in loss of performance and potential fi re when
batteries are charged.
Connecting the Battery and
Arming the ESC
Arming the ESC also occurs after binding as
previously described, but subsequent connection
of a fl ight battery requires the steps below.
If you accidentally connect the battery while
the throttle is fully opened, a musical tone will
sound after 5 seconds. Disconnect the battery
immediately.
The AS3X system will not activate until the throttle
stick or trim is increased for the fi rst time. Once
active, the control surfaces may move rapidly and
noisily on the aircraft. This is normal. The AS3X
system will remain active until the battery is
disconnected.
CAUTION: Always keep hands away from
the propeller. When armed, the motor will turn
the propeller in response to any throttle
movement.
Lower throttle
and throttle
trim to lowest
settings.
Power ON the
transmitter,
then wait 5
seconds.
1
2
3
Install fl ight
battery and
connect it to
the ESC.
Keep plane
immobile and
away from
wind for 5
seconds.
• Series of
tones
P
F