Portable Winch AC Electric pulling/lifting winch PCT1800-60Hz-P - Manual (Page 5)

5
AND THE BALDOR MOTOR LEAFLET. THE OPERATOR SHOULD BE ABLE TO OPERATE A
LIFTING DEVICE AND BE AWARE OF ALL ASPECTS OF SUCH OPERATIONS. HE SHOULD
ALSO BE AWARE OF LOCAL REGULATION.
INFORM ALL USERS OF THE SAFETY GUIDELINES AND USAGE
PROCEDURES.
FAMILIARIZE YOURSELF WITH THE PRODUCT AND THE SAFETY
GUIDELINES BEFORE WORKING WITH THIS WINCH.
MAKE SURE THAT YOUR CLOTHES ARE NOT GOING TO GET CAUGHT
INTO THE WINCH MOBILE PARTS.
USE ONLY 12 MM TO 13
MM (1/2’’) DIAMETER DOUBLE BRAID PORTABLE
WINCH CO. POLYESTER ROPE WITH THIS WINCH.
ALWAYS USE THE PCT1800 AC ELECTRIC PORTABLE CAPSTAN
PULLING/LIFTING WINCH TM HORIZONTALLY, USING A PULLEY OR THE VERTICAL PULL
WINCH SUPPORT TO REDIRECT THE ROPE VERTICALLY.
REPLACE ANY SAFETY LABELS THAT ARE DAMAGED, ILLEGIBLE OR
MISSING.
NEVER PUT YOUR HANDS ON THE CAPSTAN DRUM, THE ROPE
GRABBING SYSTEM, THE ROPE ENTRY PULLEY OR NEAR THE ROPE GUIDE WHEN THE
MOTOR IS CONNECTED TO POWER SOURCE.
ALWAYS KEEP BYSTANDERS OUTSIDE THE WORKING AREA.
NEVER PULL ROLLING OBJECTS THAT MIGHT ROLL OUT OF YOUR
CONTROL.
NEVER TRY TO MOVE FIXED OR OBSTRUCTED LOADS.
AVOID EXCESSIVE INCHING (E.G. GIVING SHORT PULSES TO THE
MOTOR).
ALWAYS INITIATE MOVEMENTS OF THE LOAD WITH THE LOWEST
AVAILABLE SPEED. THE ROPE SHALL BE TIGHTENED AND SHALL NOT BE IN THE
SLACK-CONDITION WHEN THE LOAD MOVEMENT BEGINS.
SIDE-PULL OF LOAD IS NOT ALLOWED WITH THIS WINCH.
KEEP IN MIND THAT YOUR SET-UP IS ONLY AS RESISTANT AS THE
WEAKEST LINK. THIS IS WHY IT IS VERY IMPORTANT TO USE THE ADEQUATE