Rocktron Replifex - Manual (Page 18)

15
Functions and Parameter Descriptions
The first function displayed when turning the FUNCTION SELECT control is
the Global function. The parameters provided in this function affect all presets
(i.e. the settings stored for these parameters are the same for all presets).
The PARAMETER SELECT control will allow you to access each of the following
Global parameters:
GLOBAL
Function
OUTPUT
HUSH OFFSET
MUTE
DIRECT
The OUTPUT parameter determines whether the output of the
Replifex
™ is a stereo (left and right) signal or two mono signals.
The HUSH OFFSET parameter allows you to globally (all presets)
adjust the HUSH
® Expander Threshold. This means that if this param-
eter is altered from 0dB to +3dB, the Expander Threshold will be 3dB
higher for all presets. This feature can be useful when switching from a
quiet guitar with passive electronics to a noisy guitar with active
electronics - as the active guitar would require a higher Threshold level
in all presets.
The MUTE parameter allows you to mute the output of the Replifex ™ .
This feature is especially useful when changing guitars during a live set.
When the Replifex is muted, front panel controls are disabled. However,
a MIDI program change will disable the mute (mute = out) and execute
the program change.
The MUTE parameter can be assigned to a MIDI controller number for
use with a MIDI device (such as a Rocktron All Access
™ or Rocktron
MIDI Mate ™ ).
The DIRECT parameter determines whether the direct signal is
switched in or out of the signal path. When using the Replifex™ in
applications where the unit is connected in parallel, it is recommended
that the direct signal is switched out - thereby providing 100% wet
(effect) output.