Rocktron Replifex - Manual (Page 19)

16
Functions and Parameter Descriptions
The next function displayed when turning the FUNCTION SELECT control is
the Mixer function. The Mixer function parameters are included in all presets -
regardless of which effects are active for the current preset - although the param-
eter values stored in this function are only for the currently recalled preset.
This digital mixer allows you to control the signal levels pertaining to each
preset’s configuration and stores those levels for each preset.
The PARAMETER SELECT control will allow you to access each of the following
Mixer parameters:
MIXER
Function
The LEFT DIRECT parameter determines the level of the direct signal
of the current preset at the left output.
The RIGHT DIRECT parameter determines the level of the direct
signal of the current preset at the right output.
The EFFECT LEVEL parameter determines the volume of the overall
effect signal (Chorus, Flange, Pitch Shift, etc.) level.
The DIRECT parameter determines whether the direct signal is pre-
HUSH or post-HUSH. When set to pre-HUSH, the direct signal is not
passed through the HUSH circuitry, or any other digital circuitry (i.e.,
the direct signal remains analog from input to output. When set to post-
HUSH, the direct signal is passed through the digital HUSH circuitry.
These DIR/EFF parameters determine the amount of direct signal input
to each individual effect relative to the amount of effect signal. A
setting of "0" is 100% direct signal, while a setting of "100" is 100%
effect signal.
The VOLUME parameter determines the overall signal level of the
current preset.
LEFT DIR
RIGHT DIR
EFFECT LEVEL
DIRECT
PHS DIR/EFF
CHR DIR/EFF
FLN DIR/EFF
REV DIR/EFF
VOLUME