Rocktron Replifex - Manual (Page 22)

19
The EQ function provides full parametric control and allows you shape the
tone of the input signal before it reaches each of the effect blocks.
The PARAMETER SELECT control will allow you to access each of the following
EQ parameters:
Functions and Parameter Descriptions
EQ
Function
The EQ I/O parameter determines whether the EQ circuit is active or
bypassed for the current preset.
The BASS LEVEL parameter allows you to cut or boost the low
frequencies by up to 15dB.
The BASS FREQUENCY parameter allows you to select a center
frequency between 63Hz and 500Hz to be cut or boosted by the BASS
LEVEL parameter.
The BASS BANDWIDTH parameter determines (in octaves) the width
of the selected bass band.
The MID LEVEL parameter allows you to cut or boost the mid band
frequencies by up to 15dB.
The MID FREQUENCY parameter determines a mid band center
frequency between 250Hz and 2KHz to be cut or boosted via the MID
LEVEL parameter.
The MID BANDWIDTH parameter determines (in octaves) the width
of the selected mid band.
The TREBLE LEVEL parameter allows you to cut or boost the high
band frequencies by up to 15dB.
The TREBLE FREQUENCY parameter determines a high band center
frequency between 1KHz and 8KHz to be cut or boosted via the
TREBLE LEVEL parameter.
The TREBLE BANDWIDTH parameter determines (in octaves) the
width of the selected high band.
The PRESENCE LEVEL parameter allows you to cut or boost an
additional high band frequency by up to 15dB.
The PRESENCE FREQUENCY parameter allows you to select a high
band center frequency between 2KHz and 8KHz to be cut or boosted
via thePRESENCE LEVEL parameter.
The PRESENCE BANDWIDTH parameter determines (in octaves) the
width of the selected high band.
EQ I/O
BASS LVL
BASS FREQ
BASS BW
MID LVL
MID FREQ
MID BW
TREBLE LVL
TREBL FRQ
TREBLE BW
PRESENCE LVL
PRES FREQ
PRES BW