Pecifications, Clearances – Southbend P32D-171 User Manual
Page 5
OWNER’S MANUAL 1199790 REV 0 (6/14)
PAGE 5
OF 46
I
NFRARED
B
ROILER
S
PECIFICATIONS
NOTICE
Local codes regarding installation vary greatly from one area to another. The National Fire Protection Association, Inc.
states in its NFPA 96 latest edition that local codes are the “authority having jurisdiction” when it comes to installation
requirements for equipment. Therefore, installations should comply with all local codes.
Southbend reserves the right to change specifications and product design without notice. Such revisions do not entitle
the buyer to corresponding changes, additions, or replacements for previously purchased equipment.
This product is intended for commercial use only, not for household use.
The installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code,
ANSI Z223.1, Natural Gas Installation Code, CAN/CGA-B149.1, or the Propane Installation Code CAN/CGA-B149.2,
as applicable, including:
1. The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any
pressure testing of that system at test pressures in excess of 1/2 psi (3.45 kPa).
2. The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve `
during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.45
kPa).
There must be adequate clearance between the cooking equipment and combustible construction. Clearance must
also be provided for servicing and for operation.
Minimum Clearances:
Sides
6”
Back
6”
Floor
6”
Units that have 152.4 mm (6”) legs or casters, and may be installed on combustible floors.
Adequate clearance must be provided in the aisle and at the side and rear to allow operation and serviceability.
WARNING
MINIMUM CLEARANCES FROM COMBUSTIBLE CONSTRUCTION
S
PECIFICATIONS
CLEARANCES