Southbend 20120SB - Manual (Page 5)

OPERATION
5 Printed in USA 12/02 Refrigerated Base-Self-Contained © 2002
START-UP PROCEDURE
The refrigeration system is completely factory assembled,
pre-charged and ready for operation. To energize the system
it is only necessary to find the power supply cord and
connect it to a proper electrical source. Once the supply cord
SHUT-DOWN PROCEDURE
To shut down, disconnect the electrical supply cord and open
or remove the drawer(s) allowing the interior cabinet
temperature to equalize with the room temperature. A mild
detergent diluted in warm water should be used to wash
down the interior and exterior surfaces of the cabinet.
Table 2.2 - Start-up Procedure (Refrigerated Storage)
Operation Results
1. Activate system by inserting electrical service cord into
electrical supply source and flip power control switch.
2. Locate liquid refrigerant indication glass mounted on
the receiver.
3. Wait 15 minutes.
4. Wait 3 hours.
Compressor should immediately come on line along with the
condenser fan and the evaporator fan.
Once the system has been operating for two minutes, the
glass should appear clear and full of liquid refrigerant.
The temperature in the storage area should begin to
approach the “green zone” on the thermometer indicating
adequate operation.
Once the operating temperature has been reached, stocking
of the containment area can begin.
has been connected to a power source, the unit can be
started by flipping the power control switch to the “ON”
position.
WARNING
Prior to any cleaning of the system involving placing
hands in areas with moving parts, the system should
be deactivated by disconnecting the power supply cord.
Table 2.3 - Shut Down Procedures
Operation Results
1. De-energize the system by flipping the power control
switch to the “OFF” position and disconnecting the
electrical supply cord.
Once the system is de-energized, the condenser fan and the
evaporator fan will cease operation.