Nstallation of, Estraint, Nly for – Southbend SL-Series User Manual
Page 10: Vens with, Asters)
OWNER’S MANUAL 1199740 REV 1 (10/14)
PAGE
10
OF 44
G
AS
C
ONVECTION
O
VENS
NOTICE
For an appliance equipped with casters, (1) the installation shall be made with a connector that complies with the
Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for Moveable Gas Appliances,
CAN/CGA-6.16, and a quick-disconnect device that complies with the Standard for Quick-Disconnect Devices for
Use With Gas Fuel, ANSI Z21.41, or Quick Disconnect Devices for Use with Gas Fuel, CAN1-6.9, (2) adequate
means must be provided to limit the movement of the appliance without depending on the connector and the quick-
disconnect device or its associated piping to limit the appliance movement and (3) the restraining means should be
attached to a frame member on the back of the unit.
WARNING
To avoid accidental gas disconnection and potential explosion:
If disconnection of this restraint is necessary to move the appliance for cleaning, etc., reconnect it when the
appliance is moved to its originally installed position.
1. Secure the restraining-device bracket (item “B” in the following illustration) to a wall stud located as close as possible
to the appliance connector inlet and outlet connections. Use four #12 screws (items “C”) and plastic anchors (items
“A”) if necessary.
I
NSTALLATION
S
TEP
3
:
I
NSTALLATION OF
R
ESTRAINT (
O
NLY FOR
O
VENS WITH
C
ASTERS)
F
G
H
I
B
C
E
D
A
Figure 4