Southbend B-Series - Manual (Page 16)

G AS C ONVECTION O VENS
OPERATOR’S MANUAL 1181887 REV 9 (10/14) PAGE 16 OF 44
The following describes how to assemble the optional open pan storage for G-Series and SL-Series ovens.
All holes are pre-drilled for the provided screws.
1. Attach the legs to the oven as described in installation Step 2a.
2. Attach the two frame hangers (items “A” in the following drawing). The flanged side of each hanger must be on the side
of the hanger closest to the edge of the oven.
3. Attach the pan-stop to the shelf by first inserting the tab on the bottom of the pan-stop through the slot near the
rear of the shelf, then tilting the pan-stop up to a vertical position (as shown in the following drawing). Secure the
pan-stop with a screw that passes through a hole in the shelf and into a threaded hole on the tab of the pan-stop (do
not fully tighten this screw yet). Position the shelf below the oven (for ovens with casters, rest the shelf on the top of
the caster flanges, as shown below).
LEGS NOT SHOWN
Install legs first!
Side View
Bottom View
A
A
A
I NSTALLATION
S TEP 6 : I NSTALLATION OF O PEN P AN S TORAGE ON G & SL S ERIES O VENS
(OPTIONAL)