Southbend SL-Series - Manual (Page 17)

E LECTRIC C ONVECTION O VENS
OPERATOR’S MANUAL 1181958 REV 5 (4/14) PAGE 17 OF47
WARNING
ELECTRIC GROUNDING INSTRUCTIONS
This appliance, when installed, must be electrically grounded in accordance with local codes, or in the absence of local
codes, with the National Electrical Code, ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.2, as applicable.
Step 6: Connect Electricity Supply
I NSTALLATION
Ovens are shipped wired for either single-phase or three-phase power according to the original factory order. Wiring
diagrams are located on the side of the control panel assembly, as well as in this manual (beginning on page 36). Be sure
that the input voltage and phase match the requirements shown on the serial plate, which is located inside the lower front
panel.
Conversion between single-phase and three-phase power can be performed in the field (see page 32).
The oven must be adequately grounded.
Use 167°F (75°C) wire for all supply lines.
The following drawing shows the locations of items referred to in the following procedure.
1. CHECK THAT THE POWER SUPPLY CIRCUIT BREAKER IS OPEN.
2. Locate and remove the four screws that secure the lower front panel (items “A” in the drawing above). Lift up the panel
and pull it forward to remove it, then set it aside.
3. Locate and remove the front screw (item “B” in the drawing above), that secures the lower front corner of the side
panel.
4. Locate and remove the five rear screws that secure the back edge of the side panel to the oven (items “B” in the
drawing above). Remove the side panel and insulation and set them aside.