Speck Electronics Xtramix - Manual (Page 16)

The following chart represents the proper AC terminal configuration for
the Model PS3-1.5 power supply.
The following chart represents the proper fuse rating for the
Model PS3-1.5 power supply. All fuses are 5 x 20mm Slow-Blow type.
Before connecting the DC power supply connector to the Xtramix, make
certain the power supply is not plugged in.
The power supply interface cable is a 3 conductor wire with a square
plug on one end and a rectangular plug on the other end. Do not attempt
to extend or modify this cable. Any attempt to modify this cable could
result in severe damage to the Xtramix or power supply.
To connect the power supply to the mixer, first fit the square plug into
the receptacle on the power supply. The connectors are keyed so they
will only fit in one direction. Next, fit the rectangular plug into the
connector at the rear of the Xtramix. These connectors are also keyed to
fit in only one direction. Once the plug has been connected to the
Xtramix, it may be secured with a cable tie to the adjacent cable tie
holder.
AC wiring chart
Connecting the
Power Supply
11
Fuse chart
1 AMP
1 AMP
.5 AMP
.5 AMP
.5 AMP
CAUTION! ALWAYS CHECK THE PROPER OPERATING VOLTAGE
BEFORE OPERATING THE XTRAMIX.
CAUTION! DO NOT REMOVE, DEFEAT, OR DISABLE THE SAFETY
EARTH TERMINAL ON THE POWER CORD. DO NOT USE
A GROUND LIFT ON THE POWER SUPPLY.
100 VOLTS AC
120 VOLTS AC
220 VOLTS AC
230 VOLTS AC
240 VOLTS AC
FOR USE AT:
JUMPER AT:
APPLY A.C. AT:
120 VAC
1 & 3
2 & 4
4 & 1
220 VAC
2 & 3
1 & 5
230 VAC
2 & 3
4 & 1
240 VAC
2 & 3
4 & 1
100 VAC
1 & 3
2 & 4
5 & 1
Chapter 3 Installation Section