Spectrum Controls 1734sc-OE2CIH User Manual
Spectrum Controls Measuring instruments
Advertising
Table of contents
Document Outline
- Point IO(tm) 2 Channel Isolated Output Analog HART Module
- Important Notes
- Notice
- Limited Warranty
- Preface
- Chapter 1 Module Overview
- Chapter 2
- Chapter 3
- Chapter 4
- Section 4.1 HART Features
- Section 4.2 Detecting HART Devices
- 4.2.1 Auto-Scanning of Dynamic HART Variables (PV, SV, TV, FV)
- 4.2.2 Automatically Gathering Additional Device Status
- 4.2.3 Automatically Gathering HART Device Information
- 4.2.4 HART Pass-Through Interface
- 4.2.5 Identity Object
- 4.2.6 DeviceNet Object
- 4.2.7 Assembly Object
- Channel Configuration Assembly
- HART Pass-Through Hold Time
- Fault Conditions
- Program Value
- High/Low Engineering Values (User Scaling)
- High/Low Clamp Values
- Configuration Errors
- Status Instance (100)
- Channel Status Bits
- Module Status
- Channel Hard Fault
- Watchdog Fault
- Status + HART Instances (101)
- HART STATUS BITS:
- HART STATUS BYTE 1: Communication Status
- HART STATUS BYTE 2: Field Device Status
- HART STATUS BYTE 3: Extended Device Stat
- Output Instance (102)
- Unlatch Alarm Bits
- HART Object
- HART Pass-through “Reason Code” definiti
- Ramp Rate
- Inter Processor Communications
- Main Processor Detects Error
- HART Processor Detects an Error
- Main CPU Failure
- Disabled Channels
- Technical Assistance
- Declaration of Conformity
- Appendix A
- Index