Star Headlight & Lantern 274-875-Dash Bracket - Manual

REV B 211/02 PLITSTR230
DASH MOUNT LIGHTING ACCESSORIES
Models 274-874, 274-875, 274-878,and 274-878-80
1. Remove all of the parts from the plastic bag and install the suction
cups into the holes of the dash bracket with the suction cups facing
away from the sliding plate. Attach them using the enclosed brass
knurled knobs.
2. Clean the windshield area where the suction cups will be
attached to remove any residue that may be present on the
window.
3. Position the bracket on the dash and, if necessary, bend the
metal tabs such that the suction cups are aligned with the
windshield. Press each suction cup firmly against the windshield.
4. Remove the paper backing from the enclosed foam pad and affix the
pad to the bottom of the bracket, between the bracket and the dash.
5. Mount you warning light on top of the sliding plate and adjust it
accordingly.
1. Remove all of the parts from the plastic bag and position the
black base on a firm flat surface with the metal plate facing
upward.
2. With the rounded edges facing upward, insert each of the mirrors
into the slots on the base and press them firmly into place until
the bottom is flush with the base.
3. After checking that both the base and the mounting surface are free
of dust or dirt, remove the plastic backing and affix one side of the
Velcro strips enclosed to the bottom of the base, and the other half to
your mounting surface.
4. Attach the base to the mounting surface using the Velcro and
mount your warning light on top of the base, adjusting it as
necessary.
1. After checking that both the base and the mounting surface are
free of dust or dirt, remove the plastic backing and affix one side
of the Velcro strips enclosed to the bottom of the base, and the
other half to your mounting surface.
2. Attach the base to the mounting surface using the Velcro and mount
your warning light on top of the base, adjusting it as necessary.
3. The 274-878-80 comes equipped with a magnet in place of the
Velcro, to affix the unit to a metal surface.
Model 274-874
Dash Bracket
Model 274-875
Dual-Mirror Reflector
Model 274-878 or 274-878-80
Quad-Mirror Reflector
IMPORTANT: Please read all of the following instructions before installing your new warning light.
WARNING!!!! Care should be taken when positioning any warning light on the dash, instrument panel or
visor of the vehicle, so that the light and/or cord does not interfere with the proper operation
of the airbag! Failure to heed this warning may result in serious or fatal injury.
Once your light is secured, route your cord such that it does not interfere with the vision of the driver or
the operation of any controls, including, but not limited to, the steering wheel, gear shifter, and/or airbag.