Star Headlight & Lantern ULB48 Lineum Dual-Color Traffic Director Interior LED Lightbar - Manual (Page 13)

-12-
Operating Instructions
Functions Switched Through Wires
Main control of this light is done though the wires in the harness. They should be connected
to +12VDC through several switches (user supplied) as described in the Wiring section.
TD Warn (White w/Brown)
Usually activated when a vehicle has been pulled over. The amber lights will flash in the
WARN pattern you have them programmed for.
Level 1 Flashing Mode (Orange w/Green)
This is usually intended as a slower, less urgent mode typically used when parked.
Level 2 Flashing Mode (Orange w/Red)
This mode is intended for high-urgency situations, such as a high speed chase, requiring
significant warning power. It is usually a faster pattern than Level 1.
The Level 2 pattern will override Level 1 lights.
TD Left (Green w/Yellow)
Applying +12VDC to this wire will produce a pattern directing traffic left.
TD Right (Yellow)
Applying +12VDC to this wire will produce a pattern directing traffic right.
Center-Out (Green w/Yellow) and (Yellow)
Applying +12VDC to BOTH of these wires will produce the Center-Out Pattern.
Dim Option
DIM (Green w/Red)
If the High-Low/Pattern Option is set for High-Low (see page 7), then applying +12VDC
will dim the light (typically used in nighttime applications).
Activation of Multiple Functions
Depending upon programming, the light will have different outputs when multiple functions
(i.e. switches) are activated at the same time. Please review Pattern Cycling of
Simultaneous Functions on page 10 to determine how your light is programmed.