Star Headlight & Lantern DL15-30 - Manual (Page 5)

-2-
Mounting
It is the owners sole responsibility to ensure that the mount is
secure and will not come loose while the vehicle is in motion.
1. Select a location for the light to be mounted. Take into consideration viewing angles,
mounting holes, and where the cable will run when selecting a location. The cable
should exit the driver’s side of the rear-facing stick.
2. Once you have selected the location to mount your light(s), determine which leg size
suits your application best. There are three different size legs included with the
DL15-30W Series lights: Short Leg Brackets (DL15-BKT-S), Medium Leg Brackets
(DL15-BKT-M), and Tall Leg Brackets (DL15-BKT-T).
3. Remove the two screws in one end of the light and use
them, with two of the enclosed washers, to attach one of
the mounting legs, routing the cord through the center
of the leg (shown to the right). When
installing the legs, take into account
which direction the light will face, where
the legs will mount, and which end the
cord will exit from. Select the appropriate
slots in the leg to fasten the screws
through. Repeat this step for the other
side with the other leg.
Please note: The cable needs to run through the center of the mounting bracket
as pictured above and exit the driver’s side of the rear facing DL15-30W.
CAUTION!!: In the event the endcap should become detached from the lightstick as
you are installing the legs, please take extreme care to ensure that the endcap is
replaced in the exact same orientation it was originally in. If it is not replaced
properly the weatherproof seal may be broken and the warranty will be voided.
4. Mount your light in the desired location. Use appropriate fasteners (not supplied) to secure
the legs to your mounting surface.
It is the owners sole responsibility to ensure that the mount is
secure and will not come loose while the vehicle is in motion.
DL15-BKT-M
DL15-BKT-S
DL15-BKT-T