Star Headlight & Lantern DL15-30 - Manual (Page 7)

-4-
Electrical Connections
The DL15-30W comes with a 15' six-conductor cable. The six wires perform the following
functions:
Black Wire (18AWG) - Ground
Red Wire (18AWG) - Power (operating voltage 10-16VDC)
Yellow Wire (22AWG) - Left Arrow (+12VDC)
Purple Wire (22AWG) - Center Out(+12VDC)
Green Wire (22AWG) - Right Arrow(+12VDC)
White Wire (22AWG) - Pattern Change (Touch and release to ground)
You can control your light using your own switches, with the optional SP1515-TDC (see
below), or with the optional TD77-2 (see pages 8-12).
If you will be using the OPTIONAL TD77-2 to control your light, please skip to the
corresponding section on page 8.
If you are using your own switches, you will need a 4-switch switch panel, with 4 SPST On/Off
switches.
Connecting the Optional SP1515-TDC
(you may also use your own standard On/Off switches)
1. Connect the black wire to a good chassis ground.
2. The red, yellow, purple, and green wires will be connected to your switch panel. Please
review the diagram below for proper wiring, using four SPST switches. The SP1515-
TDC (available from Star) utilizes four lighted switches. If you are using your own “non-
lighted” switches, there will be no #3 terminal on each switch, and the switch panel itself
will not need to be grounded.
3. After the black wire is grounded, and the red, yellow, purple, and green wires are
connected to your switch panel, the light is ready for operation and pattern selection.
C
O
N
N
E
C
T
T
O
+
1
2
V
D
C
STAR MODEL #SP1515-TDC
OPTIONAL LIGHTED SWITCH PANEL
(REAR VIEW)
SW3 SW2
Y
E
L
L
O
W
3
1
2
R
3
1
2
C-O
GOOD
CHASSIS
GROUND
10 AMP
FUSE
SW1
BLACK
3
1
2
1
2
3
PWR
SW4
R
E
D
L
FUSED RED LEAD
G
R
E
E
N
P
U
R
P
L
E
R
ED
YELLO
W PURPLE
GREEN
BLACK
W
HIT
E
Touch And Release to Ground
to Select Pattern, Then Cap Off
(Not used for non-lighted switches)
Please note: For non-lighted switches, there will be no Terminal #3 on each switch
and there is no ground wire (black wire) on the switch panel.