Star Headlight & Lantern DL15-30 - Manual (Page 6)

-3-
5. You must then install the enclosed tether cords, which
will help secure the light in case of impact. Attach one
tether to each leg as pictured to the right. Attach the
other end of each tether to a secure mounting point.
6. Each tether should be secured in separate locations
within 10" outside the legs of the light. Make sure there
is virtually no slack in the tethers. (See diagram below.)
CAUTION: Be sure the mount and/or fasteners used
are sufficient to support the weight of your light in
case of an accident.
7. Once the DL15-30W is mounted, you should select a location for your switch panel that is
easily accessible to the driver. The switches must be located in a dry location out of direct
sunlight, free from dirt and dust. Under the vehicle's instrument panel is usually the best
choice. You may use your own switches, or you may order the SP1515-TDC, TD77-2, or the
TDC850 (for use with SVP sirens that have built-in traffic director controls). If you are using
your own switches, you will need a 4-switch switch panel, with 4 SPST On/Off switches.
TD77-2
(Optional Controller w/LED Display)
SP1515-TDC
(Optional Switch Panel)
TDC850
(Optional Controller for use w/SVP sirens)
8. Mount your switch panel using appropriate fasteners (not supplied).
9. Once the light and switch panel are secured, route your cable to your switch such that it does
not interfere with the vision of the driver or the operation of the steering wheel, gear shifter,
and/or any airbags.
(Mounting CONT’D)