Star Headlight & Lantern TD93DLXT - Manual (Page 2)

-i-
Important : This product is used to direct traffic. Improper use may
result in vehicular collision, personal injury and/or death. Star
Headlight & Lantern Co., Inc., and its subsidiaries shall not be held
responsible for damages directly or indirectly caused by improper use
of this product. Always carefully consider the effect on traffic that the
selected light pattern will have before engaging the lights.
Before beginning the installation:
- Determine where the Traffic Director is to be mounted (on your lightbar, on
your roof, in your rear window, etc.
- Check to see that there are no obstructions hindering the visibility of your
traffic director.
- Then select a location to mount your controller. The controller must be
located in a dry location out of direct sunlight, free of dirt and dust. Under the
vehicle's instrument panel is usually the best choice.
- Once you have selected these locations, determine the path your cable,
which connects the controller to the Traffic Director, will take. The cable
should exit the left side of the Traffic Director when you are facing both the
stick and the controller.
Depending upon the specific model number, the TD92 and TD93 series come
with either a 15’, 30’, 45’, or 60’ cable pre-installed.
The TD93DLXT series come with a short pigtail out of the side of the light that
attaches to the main harness. The available lengths for the harnesses are 15',
30', 45', and 60'.
Be sure the harness attached to your Traffic Director is long enough for proper
installation. Star does not recommend “splicing in” additional cable when
the supplied cable is too short. If it is too short, you will need to order a
Traffic Director with the correct length cable pre-installed (TD92 and TD93), or
you will need to order a harness of the correct length (TD93DLXT).