Star Headlight & Lantern TD93DLXT - Manual (Page 4)

-1-
NOTICE
Due to continuous product improvements, we must reserve the right to change any
specifications and information, contained in this manual at any time without notice.
Star Headlight & Lantern Co., Inc. makes no warranty of any kind with regard to this
manual, including, but not limited to, the implied warranties of merchantability and
fitness for a particular purpose. Star Headlight & Lantern Co., Inc. shall not be liable
for errors contained herein or for incidental or consequential damages in connection
with the furnishing, performance, or use of this manual.
Please Note: These instructions are provided as a general guideline only. Some
vehicles may require special mounting, wiring, and/or weather-sealing. This is the
sole responsibility of the installer. Star Headlight & Lantern Co., Inc. assumes no
responsibility for the integrity of the installation for this or any of its products.
1. Caution: There are two vapor vent holes drilled in the bottom slot of the TD92. Check
the extrusion for these holes to be sure they are located at the bottom when you mount
the bar.
2. Each bar light assembly comes equipped with slots along the entire length of the
extrusion that will retain ¼” hex head bolts. The TD92 has slots along the top, bottom,
and rear. The TD93 and TD93DLXT only have slots along the rear.
3. Two “L”-Brackets are included with each traffic director to assist in mounting it to a
lightbar or other secure base. The #TD77-6K L-Bracket Kit is shipped with the TD92.
The 274-LLBK L-Bracket Kit is shipped with the TD93 and TD93DLXT.
Mounting Instructions
TD77-6K
274-LLBK
4. Also included are four ¼” x 20 x ¾” hex head bolts, four flat washers, four split washers,
and four nuts to attach the L-Brackets to your traffic director. You can mount your traffic
director directly to your vehicle using the enclosed bolts or your own ¼“ hex head bolts.
You may also use the enclosed hardware to mount the L-Brackets to your traffic director.