Star Headlight & Lantern VL22 StarVisor I - Manual (Page 2)

Mounting
1. The
STARVISION II™ Visor Light comes equipped
with two Velcro straps for standard visor
mounting. Please read all of the following
instructions before installing your new
STARVISION II™ Visor Light .
2. Place the vehicle’s sun visor in the “down”
position. (Typically the passenger side visor.)
3. Place the
STARVISION II™ Visor Light in front of the
vehicle’s sun visor, with the cigarette plug cord exiting the
top of the light. Please Note: The VL22 must be mounted
with the power cord exiting the top of the light or the tilt-switch
will not function properly.
4. With the flat side of the light mounted against the visor and the LEDs
pointing towards the windshield, adjust the straps so that the light may be
slid over the end of the visor.
5. Once in place, tighten the straps to the desired tension.
6. Route the wire across the top of the visor and down to
your cigarette plug outlet.
Passenger side
mounting is shown
here. Please note that
the cord is routed such
that it runs towards the
outside of the
windshield and does
not obstruct the view of
the driver.
CAUTION!!! Once the light is secured,
route your cord such that it does not
interfere with the vision of the driver or
the operation of the steering wheel, gear
shifter, and/or any airbags.
Warning: It is the owners sole responsibility to ensure
that the mount is secure and will not come
loose while the vehicle is in motion.