Figure 9: unit id select switch location – StorCase Technology DE300i-SWC160 User Manual
Page 20
DE300i-SWC160 User's Guide - Rev. B00
StorCase Technology, Inc.
Installation
13
Figure 9: Unit ID Select Switch Location
WARNING:
Selecting an invalid ID number, or selecting the same unit ID
number on different devices may cause unpredictable results
and the computer system may not recognize the installed de-
vice(s). If the computer system can not recognize the boot disk,
the computer may fail to start-up properly.
4.
After selecting an appropriate unit ID number, replace the DE300i-SWC160
carrier in the receiving frame, and LOCK IT INTO PLACE.
5.
The new drive(s) may need to be formatted or initialized prior to use with the
operating system and applications software. Refer to the drive and/or
computer manufacturer's documentation for formatting information.