Configuring the infostation for dual-channel, Figure 11: removing the i/o blank plate – StorCase Technology 14-Bay 4U SCSI Ultra160 User Manual
Page 17
12
Installation
StorCase Technology, Inc.
InfoStation 14-Bay Installation Guide - Rev. C00
Configuring the InfoStation for Dual-Channel
CAUTION:
Remove ALL power from the InfoStation before removing the I/O module.
The I/O module contains NO USER SERVICEABLE PARTS inside the unit.
Refer ALL servicing to qualified service personnel!
NOTE:
Optional I/O interfaces are available as an upgrade. Contact StorCase for
further ordering information.
1.
Unplug the InfoStation and verify that all cables have been disconnected.
2.
Place the InfoStation on a soft clean surface to protect finish of the chassis.
3.
Loosen and remove the two (2) #6-32 Phillips F. H. screws securing the I/O blank
plate to the InfoStation chassis (Figure 11). Correct dual-channel rear configuration
is shown in Figure 12.
4.
Remove the I/O blank plate.
5.
Remove access panel (as described on page 10).
6.
Remove the center jumper block so that the second I/O module and terminator can
be installed. Correct dual-channel backplane configuration is shown in Figure 13.
Figure 11: Removing the I/O Blank Plate
I/O Blank
Plate
#6-32 Phillips
Flat Hd. Screw
(2 Total)
IFS14_11