Configuring the infostation for 4-channel, Figure 14: 4-channel backplane configuration – StorCase Technology 14-Bay 4U SCSI Ultra160 User Manual
Page 19
14
Installation
StorCase Technology, Inc.
InfoStation 14-Bay Installation Guide - Rev. C00
Figure 14: 4-Channel Backplane Configuration
I/O
Module
Terminator
Block
I/O
Module
Terminator
Block
Terminator
Block
IFS14_22
Terminator
Block
I/O
Module
I/O
Module
Configuring the InfoStation for 4-Channel
CAUTION:
Remove ALL power from the InfoStation before removing the I/O module.
The I/O module contains NO USER SERVICEABLE PARTS inside the unit.
Refer ALL servicing to qualified service personnel!
NOTE:
Optional I/O interfaces are available as an upgrade. Contact StorCase for
further ordering information.
1. Unplug the InfoStation and verify that ALL cables have been disconnected.
2. Place the InfoStation on a soft clean surface to protect finish of the chassis.
3. Loosen and remove the two (2) #6-32 Phillips F. H. screws securing each I/O blank
plate to the InfoStation chassis (Figure 11).
4. Remove all three (3) I/O blank plates.
5. Remove access panel (as described on page 10).
6. Remove all the jumper blocks so that I/O modules ( #2, 3, and 4) and terminators (#2,
3, and 4) can be installed. Correct 4-channel backplane configuration is shown in
Figure 14.