TracRac IM T-Rac G2 - Manual (Page 11)

TracRac Inc. 994 Jefferson St. Fall River, MA 02721 l 800-501-1578 Instruction Manual
Remove the plastic end-caps from the factory 1.
installed rails, front and back.
Take the Tacoma Tool Box Mount Clamp and 2.
partially thread a 3/8”-16 hex head cap screw
through the tapped hole located on the bottom
of the clamp.
Slide two clamps into each factory installed 3.
rail from the back end of the truck and replace
the rear end-caps.
Slide three clamps into each factory installed 4.
rail from the front end of the truck and replace
the front end-caps.
With the clamps retained in the track now 5.
slide 2 of them on each upright base, with
the base in the desired location place a 3” U
channel on top of the hex head caps screws.
Reference the placement of the uprights from
the included installation book.
Place a rubber shim and tool box shim under 6.
the two remaining clamps along with a 7/8” U
channel on top of the hex head caps screws.
Torque the hex head cap screws down to 14 7.
lb-ft using a 9/16” open end wrench.
Follow the remaining steps in Part 4 of 8.
directions above to install the toolbox.
The 3” U Channel and 3/8”-16 Hex Head Cap •
Screw are included with the original rack
hardware.
Button Head
Cap Screw
3/8 Washer
Aluminum
Shim
Plastic Shim
U-Channel
Hex Head
Cap Screw
Tacoma
Clamp
When Complete
Toyota Tacoma Toolbox Installation