TracRac IM T-Rac G2 - Manual (Page 6)

TracRac Inc. 994 Jefferson St. Fall River, MA 02721 l 800-501-1578 Instruction Manual
Upright Assembly
First take the upright (Item 3) and insert it into a 1.
modular saddle (Item 5).
Bolt the saddle through the top by using two 3/8”-16 2.
FHCS (Item 16) and tighten using a 7/32” Allen Key
(or 7/32” Allen Drive Bit) Torque the 3/8” -16 FHCS
to 32 ft-lbs. We recommend threading both flat
head cap screw initially by hand to ensure that you
don’t cross thread the bolt.
When tightening the 3/8” FHCS ensure that the
Allen Key is fully seated in the bolt so that it will not
strip
Now take the upright and saddle and bolt it to the 3.
modular base (Item 2)
For the other front upright repeat steps one through 4.
four, except use Item 6 in Step 3.
NOTE: Item 2 and Item 6 are mirror images of each
other. Reference the packing checklist to confirm what
part to use.
Repeat Steps 1-4 on the rear uprights 5.
With the upright, saddle and base assembled, 6.
secure one of the upright cleats (Item 9) with two
1/4”-20 SHCS (Item 27) to the upright. Torque the
1/4”-20 SHCS to 6 ft-lbs.
Repeat Step 7 on each of the uprights. 7.
Step 1
When Step 1 is complete, you will have 4 uprights.
Part 1 - Uprights
Note:
Both
surfaces
must be
parallel
with each
other
16
5
3
9
27
2 or 6