Ubiquiti Networks airFibe24 - Manual (Page 13)

5. Click the Wireless tab.
6. Enter the Basic Wireless Settings:
a. For one airFiber AF-24, select Master from the Wireless Mode
drop-down. For the other airFiber AF-24, keep the default,
Slave.
b. Enter a name in the Link Name field. This should be the
same on both the Master and the Slave.
c. For the Duplex drop-down:
- Half Duplex The default mode. The TX and RX Frequencies
can be the same or different to suit local interference.
- Full Duplex The TX and RX Frequencies should be different.
d. Select a TX Frequency. This must match the RX Frequency on
your other airFiber AF-24.
e. Select a RX Frequency. This must match the TX Frequency of
your other airFiber AF-24.
f. If needed, change the Output Power, Maximum Modulation
Rate, and/or RX Gain settings.
11
airFiber Configuration