UVP 81-0357-01 PCR Hoods - Manual (Page 7)

PCR Workstations and Cabinets Page 7
Inner Back Panel
1. Position the Inner Back Panel so that the screw holes align with the Outer Back Panel. Attach the
Inner Back Panel to the Outer Back Panel with two (2) screws, as shown. Make sure the wires
come out of the cutout in the back panel, as shown by the red circle below, for later connection to
the Top Assembly.
2. Secure the Shelf Bracket to the front of the Inner Back Panel using:
a. Eight (8) screws in the Workstation or
b. Six (6) screws in the Cabinet
NOTE: Two people are required to hold the panels in place and insert the screws. Leave the
screws loose (do not fully tighten at this time).
Makrolon
®
Panel Assembly
1. Slide the Makrolon
®
Panel Frames for the Makrolon
®
Panels under the screws on the Inner Back
Panel so that the Frames are under the Shelf Bracket. Note that the Panel Frames are oriented so
that the left Frame cannot be used on the right side and vice versa. See illustrations below.
2. Remove the protective film from the Makrolon
®
Panels.
3. Slide the Panels into position between the Frames and the lips on the sides of the Inner Back
Panel. Ensure that the Makrolon
®
Panels are pushed all the way against the Inner Back Panel.
4. Press the Frames tightly against the Makrolon ® Panels.
Inner Back Panel
Shelf Bracket
Position the Inner Back
Panel so that the edge of
the frame rests against the
stainless steel base
Cutout for wires
Inner Back Panel
Screw
Inner Back Panel
Screw
Shelf Bracket
Screws
(8 Shown)