Installation steps – WaterFurnace Envisio Series Console User Manual
Page 13
13
ENVISION CONSOLE - 50 HZ INSTALLATION MANUAL
Step 1: Unpack Equipment and Inspect for Damage
Step 2: Determine Equipment Location
• Choose level flooring surface (Correctable with shims.
Do not pitch towards drain.)
• Location of wall support and fasteners required to
secure chassis backplate.
• Easy access for both installation and service.
• Consider availability and ease of wiring, water piping and
condensate drain.
• No obstructions to block airflow in front of the unit.
Step 3: Mark Unit Position
• Ensure that floor is level. If shims are required, make
sure that the entire compressor compartment area is
uniformly shimmed and that the backplate mounting
height is increased by the thickness of the shims used.
1=<A=:3
1/07<3B
1=<A=:3
16/AA7A
1=<23<A/B3
2@/7<:=1/B7=<
=>B7=</:6=A3A
0/::D/:D3A
=>B7=</:
>B>:C5A
=>B7=</:
E/B3@
=CB
E/B3@
7<
1=<A=:31/07<3B
0/19>:/B3
=>B7=</:
E/::>3<3B@/B7=<
4=@E/B3@1=<<31B7=<
4:==@>3<3B@/B7=<
4=@E/B3@1=<<31B7=<
4CA323:31B@71/:
27A1=<<31B=>B7=</:
;=B=@7H32
2/;>3@
=>B7=</:
;=B=@7H32
2/;>3@
=>3<7<5
Figure 1
Installation Steps
• Position backplate in desired equipment location. To
further reduce the operating sound level of the unit,
1/8 in. thick rubber matting may be placed under the
chassis to eliminate vibration on hard flooring surfaces.
(Make sure back plate is level).
• Mark and cut floor or wall penetrations for electrical
wiring, water and condensate piping.
Optional Electrical Disconnect and Motorized
Outside Air Damper
• Mark and cut wall penetrations for field fabricated
outside air duct sleeve.
• Align mounting holes with backplate and attach with
screws supplied.