Z-Systems z-Q6 six-channel mastering equalizer - Manual (Page 4)

z-Q6 manual
4
Selecting Active Channel Group
LRS CEN SUB LRF
Figure 3 - channel selection mode
The z-Q6 can not display the filter parameters for all channels at once, so it uses a "paging" mode
where the EQ parameters are displayed and controlled one channel group at a time. To change
the active channel group, press the channel select button once. The display will appear as in
Figure 3. Choose which channel group you wish to control by pressing the button below the
appropriate display. The z-Q6 will then jump back to EQ mode, with the selected channel group
as the new active channel.
Controlling Master Level and Channel Offsets
-02.0 +00.0
RF LS RS *CEN SUB
+00.0 -02.4
(M knob) offsets:
(R knob) master: -02.4
+00.0 -03.0
LF
Figure 4 - volume control mode
Press the EQ/volume select button to toggle between EQ and volume control modes. The display
will appear as in Figure 4. In volume control mode you can alter the master system level and the
level offsets of all six individual channels. These levels are all referenced to full-scale digital
(dBFS). The level of each channel will track the master level, with a relative level shift determined
by the offset.
To control the overall system level use the right knob, as prompted by the display. To control an
individual level offset, press the button below the desired channel, as shown in Figure 4. An