Ryobi HP37 - Manual (Page 10)

10 — English
1
22
19
16
OPERATION
CHARGING STAND
If you decide to use the charging stand, it can either be
mounted to a wall or placed on a flat surface to charge. The
charging stand also has four slots to store bits.
TO MOUNT CHARGING STAND
See Figures 3 - 4.

Locate close to an electrical outlet.
NOTE: With screwdriver in stick position, temporarily
place screwdriver in charging stand. Check to make sure
it will not interfere with the charger or electrical outlet.
 Remove screwdriver
 Insert charger plug into back of charging stand arranging
wire and plug as shown in Figure 3.
 Drill two () pilot holes then insert the two () wall anchors
provided.
NOTE: Pilot holes should be -5/8 inches apart.

Position charging stand on wall aligning holes in charging
stand with pilot holes.
 Secure charging stand with the two () screws
provided.
TO CHARGE SCREWDRIVER USING
CHARGING STAND
See Figure 5.
 Place screwdriver in charging stand making sure input
jack and charger plug are properly connected.
 Align slots on screwdriver with tabs on charging stand
then push on screwdriver to snap into place.
 Connect charger to power supply.
 After normal usage, a minimum of 10 hours of charging
time is required to fully charge screwdriver.
 Do not place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
STICk/PISTOL COMBINATION
See Figure 6.
The screwdriver has been designed so that it can be used
as a stick screwdriver or a pistol screwdriver. A rotation
button is located on the side of the screwdriver. To place
the screwdriver in pistol position, hold it in normal operating
position, depress rotation button and push down on handle.
To place the screwdriver in stick position, hold it in normal
operating position, depress rotation button and pull up on
handle.
COLLET
See Figure 7.
The collet on the screwdriver has been designed to accept
1/4 in. hex bits.
TO INSERT BIT
See Figure 7.
Insert bit into collet as far as possible.
1
22
19
16
Fig. 5
CHARGER
PLUG
CHARGER
INPUT JACK
CHARGING
STAND
SLOTS
TAB
TAB
1
22
19
16
ROTATION
BUTTON
HANDLE
BIT
COLLET
13
16
10
LIGHT SWITCH
LIGHT
Fig. 6
Fig. 7
Fig. 8