Operation, Filling the tank, Warning – Ryobi P2400 User Manual
Page 12
12
4
3
2
1
oz
120
100
80
60
40
20
ml
OPERATION
Fig. 7
Fig. 8
TO INSTALL THE BATTERY PACK
See Figure 7.
Make sure the trigger is not in the locked-on position.
Place the battery pack into the battery port. Slide the
battery pack into the sprayer.
Make sure the latches on each side of the battery pack
slide into place and the battery pack is secured in the
sprayer before beginning operation.
NOTE: The battery pack should be recharged after
approximately 5 hours of use to reduce the possibility of
damage. Repeated deep discharge of the battery may
decrease storage capacity and battery life.
TO REMOVE THE BATTERY PACK
See Figure 7.
Depress the latches on the side of the battery pack.
Remove the battery pack.
FILLING THE TANK
See Figure 8.
WARNING:
Always follow the chemical manufacturer’s instructions
printed on their product labeling for use, cleaning, and
storage. Clean thoroughly after each use, following the
instructions in the Maintenance section of this manual.
Chemicals should be stored out of the reach of children.
Failure to do so may result in serious personal injury.
Liquids to be sprayed must be as thin as water. Thicker
liquids will not spray properly.
Do not overfill the tank.
To mix a spray solution in the tank:
Remove the battery pack.
Unscrew the measuring cap and remove it from the
tank.
Fill the tank with the desired amount of water (up to
1 gallon).
Measure the recommended amount of liquid. The cap
may be used for measuring up to 4 oz.
Carefully pour the liquid into the tank.
Rinse the measuring cap with clean water.
Screw the cap back onto the sprayer, making sure it is
tightened securely.
Reinstall the battery pack.
Spray solutions may be premixed and poured into the sprayer,
using a funnel if needed.
NOTE: If using a measuring container other than the cap, or if
using a funnel to fill the tank, be sure to thoroughly clean and
rinse these items after use. If premixing the spray solution,
rinse the container used for mixing.
BATTERY
PACK
LATCH
CAP
TANK
FILL AREA