Mini 2003 Cooper User Manual

Page 34

Advertising
background image

32

ALARM SYSTEM

*

>Indicator lamp goes out when the sys-

tem is disarmed:
No tampering with your vehicle has been
detected

>Indicator lamp continues to flash at a

slow rate after the system is disarmed:
Your vehicle has been tampered with.
The indicator lamp will not go out until
the ignition key is turned in the ignition
lock or the alarm system is re-armed.

Interior motion sensor:
>Indicator lamp does not react:

Doors or tailgate are not properly closed

>Indicator lamp flashes constantly:

Only driver/passenger window and slid-
ing/tilt sunroof is open.
Interior motion sensor is not activated.
Alarm system is armed

>Indicator lamp is lit somewhat longer

and then flashes constantly:
Window and/or sliding/tilt sunroof were
closed after the system was armed:
interior motion sensor is not activated.

Avoiding

unwanted alarm

The tilt alarm and interior motion sensors
may be turned off at the same time. This
will prevent unwanted alarms, e.g. in
duplex garages or when on car transport
trains:

Lock the vehicle twice – activating:

Press button 2 of the remote control twice
in succession, see page

25

or

lock with the key twice, see page

25

.

The indicator lamp goes from fast blinking
to regular blinking. After approx. ten sec-
onds the indicator lamp changes to con-
stant flashing. The tilt alarm and interior
motion sensors are deactivated until the
system is disarmed.

Interior motion sensor

Transmitter and receiver of the interior
motion sensor system are found under a
cover in the vehicle roof.

For the interior motion sensor to function
properly, the windows, sliding/tilt sunroof
and doors must be closed.

Turn off the interior motion sensor – see
previous column – if
>children or animals remain in the vehicle

>windows or the sliding/tilt sunroof

remain open.

The tilt alarm and interior motion
sensors are inadvertently turned off if

the convenience closing of windows and
sliding/tilt sunroof is interrupted in the
first 10 seconds and then restarted. The
alarm must then be disarmed and reacti-
vated.

<

ba.book Seite 32 Montag, 5. August 2002 8:09 20

Online Edition for Part-No. 01 41 0 156 890 - © 09/02 BMW AG

Advertising