Probable cause, Suggested actions – Altera Nios II User Manual
Page 34
Advertising
D–4
Appendix D: Troubleshooting
"Base address not aligned on size of device" Error
Nios II Flash Programmer User Guide
© March 2014
Altera Corporation
Probable Cause
The flash device base address being passed to the Flash Programmer is not a multiple
of the flash device's size.
Suggested Actions
■
Ensure that the flash device is mapped to a base address in Qsys that is a multiple
of the flash size listed in its CFI table.
■
If in command line mode, ensure that the --base parameter you are passing to
nios2-flash-programmer
is the correct base address of the flash device in your
Qsys system.
Advertising