Mercedes-Benz 2013 C Class Coupe - Manual (Page 234)

Switching the Intelligent Light System
on/off
X Press the = or ; button on the steer-
ing wheel to select the
Settings menu.
X Press the : or 9 button to select the
Light submenu.
X Press a to confirm.
X Press the : or 9 button to select the
Intell. Light System function.
If the Intell. Light System function has
been switched on, the cone of light and the
L symbol in the multifunction display
are shown in orange.
X Press the a button to save the setting.
When you activate Intell. Light System ,
you activate the following functions:
R
Motorway mode
R
Active light function
R
Cornering light function
R
Extended range foglamps
If you set the dipped-beam headlamps for
driving on the right/left, the multifunction
display shows the
Intell. Light System:
System inoperative Inactive for
left-side traffic or Intell. Light
System: System inoperative Inactive
for right-side traffic display message
instead of the Intell. Light System:
function in the Light submenu.
Further information on the Intelligent Light
System (
Y page 122).
Setting the dipped-beam headlamps for
driving on the left/right
X Press the = or ; button on the steer-
ing wheel to select the
Settings menu.
X Press the : or 9 button to select the
Light submenu.
X Press a to confirm.
X Press the : or 9 button to select the
Dipped beams Setting for: function.
You will see the selected setting: Right-
side traffic or Left-side traffic .
X Press the a button to save the setting.
If you change the setting, conversion does
not take place until the next time the vehi-
cle is stationary.
This function is only available on vehicles with
the Intelligent Light System.
You can use this function to switch between
symmetrical and asymmetrical dipped beam
(
Y page 118).
If you set the dipped-beam headlamps for
driving on the right/left, then motorway
mode and the extended range foglamps are
unavailable.
A qualified specialist workshop can set the
dipped-beam headlamps for driving on the
right or left.
Switching Adaptive Highbeam Assist on/
off
X Press the = or ; button on the steer-
ing wheel to select the
Settings menu.
X Press the : or 9 button to select the
Light submenu.
X Press a to confirm.
X Press the : or 9 button to select the
Adapt. main beam function.
If the Adapt. main beam function has
been switched on, the cone of light and the
_ symbol in the multifunction display
are shown in orange.
X Press the a button to save the setting.
For further information about Adaptive High-
beam Assist, see (
Y page 123).
Activating/deactivating the surround
lighting and exterior lighting delayed
switch-off
X Press the = or ; button on the steer-
ing wheel to select the
Settings menu.
X Press the : or 9 button to select the
Light submenu.
232
Displays and operation (12-button multifunction steering wheel)
On-board computer and displays