Optoma ZF2100 System - Manual (Page 11)

Copyright 2011 Bit Cauldron Corporation Page 11 of 28
3D Emitter & Glasses Pairing Mode: Pairing the Optoma BC100B Emitter with Optoma
ZF2100 Glasses
The emitter may operate an unlimited number of glasses at any given time. However, the emitter may
choose to uniquely pair with a maximum of eight glasses.
After placing the Optoma BC100B Emitter in pairing mode, you will see the red “in‐search‐of‐a‐pair light
sequence” heartbeat.
The Optoma BC100B Emitter will remain in pairing mode for one minute. During that time, multiple
glasses may be paired with the Optoma BC100B Emitter. The only indication that pairing is successful
will occur at the glasses. When the Optoma BC100B Emitter cannot pair to any more devices, it will
display the “all available pairs already memorized” signal indicated by five red LED’s blinking all‐on and
all‐off for ten seconds. The emitter will then return to normal operation. The device must be reset to
factory defaults to clear the memorized pair list.