MIPRO mr515a(2ce228) - Manual (Page 6)

10
1. When microphone isswitched on:
At the moment of the power is switched on, the indicator will flash briefly
indicating normal operation.
SIGNAL LED indicator of receiver glows.
More LEDindicators shows received signal strength is strong.
AUDIO LED displays received AF level from the microphone.
(a) When power o n:
(b) After power on:
(c) During Usage:
(d) When the microphoneis not in use:
Make sure the power of the microphone isoff. Ifthe microphone will
not be used for some time, please remove the batteries from the
battery compartment t o avoid battery leakage andresult in damaged
battery springs and circuit. I f a rechargeable battery was used, take it
out and recharge it.
1. Unscrew battery cap (6) in a counter-clockwise direction.
2. Inser two 1.5V(AA) battery into the battery compartment observing the
correct polarity. The moment the battery touches the terminals of the
compartment, the indicator will flash briefly . This means the polarity is
correct. However, if no flashoccurs, this indicates wrong insertion or
battery is dead. Please re-insert the battery observing its correct polarity or
change to a fresh battery.
2. BATTERY INSERTION
(Fig.2)
3. OPERATING INSTRUCTIONS
BODYPACK TRANSMITTER BODYPACK TRANSMITTER
9
1. PARTS NAMES AND FUNCTIONS
5
6
8
7
4
1
2
3
(Fig.1)
1. AF Input Jack: Connects t o a lavaliere or headset microphone. (See 5 ways
of connection on AF Input Connections)
2. Power Switch: Switch to O N position for operation.Switch to OFF position
when not in use.
3. Battery Status Indicator: Indicates the poweron / off andbattery status.
(a) When power switch is turned on: The LED indicator flashes briefly,
indicating normal battery status.
(b) When RED light illuminates at either power o n o r during usage: The
battery level is low, therefore, a new battery replacement is thus necessary.
4. TransmitterHousing: Packages the PCB andbattery.
5. Gain Control: Adjusts thedesirous input gain.
6. GT/MT Level Selector: Switch GT position for electric guitar usage ONLY.
Gain Control is irrelevant f o r "GT". Switch to "MT" for condenser
microphone, wiredmicrophone. Gain Control works in "MT" for input
sensitivity adjusting.
7. Battery Compartment and Cover: Accommodates two 1.5V(AA) batteries.