Alto Professional ELVIS 15SA MKII - Manual (Page 4)

HOOK
UP
2. QUICK START - PASSIVE SPEAKER CABINET
If you use a powered mixer for the passive speakers, it is no need to use an
amplifier. make sure all the main volume controls of your power mixer are turned
down completely.
1). Connect one side of the speaker cable to the SPEAKER OUT of your powered
mixer and the other side to the Input socket of your Elvis speaker cabinet.
2). Use PFL function to get the proper input level for the mixer, and adjust the
Main Mix Level control to manipulate the output level.
2
3). After use, turn down of the Main Mix Level control first, then turn off the
powered mixer.
Passive, Full-range, two speakers. This is the simplest set-up. You just need
a mixer and a stereo amplifier. It is good for small club gigs, disco,etc.
Make all initial connections with all the equipment powered off, and ensure that
all the main volume controls are turned down completely.
1). Connect one side of the speaker cable to the Output CHA/CHB or Binding
Post of your stereo power amplifier and the other side to the Input socket
of your Elvis speaker cabinet.
2). Complete other connections as illustrated.
3). Turn on your mixer first, then the stereo power amplifier.
4). Turn up the volume controls of your amplifier to about 70%.
5). Use PFL function to get the proper input level for the mixer, and adjust the
Main Mix Level control to manipulate the output level.
6). After use, turn off your stereo power amplifier first, then the mixer.
LINE IN
MAIN OUT L
POWERED MIXER
LINE IN
MAIN OUT R
MIXER
STEREO AMPLIFIER
D1
500W 2 500W 2
(dB) 12 16 18 20 22 24 26 28 30 6 CH1 (dB) 12 16 18 20 22 24 26 28 30 6 CH2
SIG CLIP PROT SIG CLIP PROT
12 CHANNEL 1000 WATT POWERED MIXER WITH 24-BIT MULTI-EFFECTS PROCESSOR
LTO R APM120