Applied Motion STM17C-3CE - Manual (Page 6)

Safety Instructions
Only qualified personnel are permitted to transport, assemble, commission, and maintain this equipment. Properly quali-
fied personnel are persons who are familiar with the transport, assembly, installation, commissioning and operation of
motors, and who have the appropriate qualifications for their jobs. The qualified personnel must know and observe the
following standards and regulations:
IEC 364 resp. CENELEC HD 384 or DIN VDE 0100
IEC report 664 or DIN VDE 0110
National regulations for safety and accident prevention or VBG 4
To minimize the risk of potential safety problems, you should follow all applicable local and national codes that regulate
the installation and operation of your equipment. These codes vary from area to area and it is your responsibility to de-
termine which codes should be followed, and to verify that the equipment, installation, and operation are in compliance
with the latest revision of these codes.
Equipment damage or serious injury to personnel can result from the failure to follow all applicable codes and standards.
We do not guarantee the products described in this publication are suitable for your particular application, nor do we
assume any responsibility for your product design, installation, or operation.
• Read all available documentation before assembly and commissioning. Incorrect handling of products in this manual
can result in injury and damage to persons and machinery. Strictly adhere to the technical information on the installation
requirements.
• It is vital to ensure that all system components are connected to earth ground. Electrical safety is impossible without a
low-resistance earth connection.
• The STM17 drives contain electrostatically sensitive components that can be damaged by incorrect handling. Dis-
charge yourself before touching the product. Avoid contact with high insulating materials (artificial fabrics, plastic film,
etc.). Place the product on a conductive surface.
• During operation keep all covers and cabinet doors shut. Otherwise, there are deadly hazards that could possibly
cause severe damage to health or the product.
• In operation, depending on the degree of enclosure protection, the product can have bare components that are live
or have hot surfaces. Control and power cables can carry a high voltage even when the motor is not rotating.
• Never pull out or plug in the product while the system is live. There is a danger of electric arcing and danger to per-
sons and contacts.
• After powering down the product, wait at least ten minutes before touching live sections of the equipment or undoing
connections (e.g., contacts, screwed connections). Capacitors can store dangerous voltages for long periods of time after
power has been switched off. To be safe, measure the contact points with a meter before touching.
Be alert to the potential for personal injury. Follow the recommended precautions and safe operating practices included
with the alert symbols. Safety notices in this manual provide important information. Read and be familiar with these
instructions before attempting installation, operation, or maintenance. The purpose of this section is to alert users to
possible safety hazards associated with this equipment and the precautions that need to be taken to reduce the risk of
personal injury and damage to the equipment.
Failure to observe these precautions could result in serious bodily injury, damage to the equipment, or operational dif-
ficulty.
6
STM17 Hardware Manual
920-0034 rev A
9/30/2010