Applied Motion STM23C-3CE - Manual (Page 7)

Safety Instructions
Only qualified personnel are permitted to transport, assemble, commission, and maintain this equipment. Prop-
erly qualified personnel are persons who are familiar with the transport, assembly, installation, commissioning and
operation of motors, and who have the appropriate qualifications for their jobs. The qualified personnel must know
and observe the following standards and regulations:
IEC 364 resp. CENELEC HD 384 or DIN VDE 0100
IEC report 664 or DIN VDE 0110
National regulations for safety and accident prevention or VBG 4
To minimize the risk of potential safety problems, you should follow all applicable local and national codes that reg-
ulate the installation and operation of your equipment. These codes vary from area to area and it is your responsi-
bility to determine which codes should be followed, and to verify that the equipment, installation, and operation
are in compliance with the latest revision of these codes.
Equipment damage or serious injury to personnel can result from the failure to follow all applicable codes and stan-
dards. We do not guarantee the products described in this publication are suitable for your particular application,
nor do we assume any responsibility for your product design, installation, or operation.
• Read all available documentation before assembly and commissioning. Incorrect handling of products in this
manual can result in injury and damage to persons and machinery. Strictly adhere to the technical information
on the installation requirements.
• It is vital to ensure that all system components are connected to earth ground. Electrical safety is impossible
without a low-resistance earth connection.
• The STM23 drives contain electrostatically sensitive components that can be damaged by incorrect han-
dling. Discharge yourself before touching the product. Avoid contact with high insulating materials (artificial
fabrics, plastic film, etc.). Place the product on a conductive surface.
• During operation keep all covers and cabinet doors shut. Otherwise, there are deadly hazards that could
possibility cause severe damage to health or the product.
• In operation, depending on the degree of enclosure protection, the product can have bare components
that are live or have hot surfaces. Control and power cables can carry a high voltage even when the motor is
not rotating.
• Never pull out or plug in the product while the system is live. There is a danger of electric arcing and danger
to persons and contacts.
• After powering down the product, wait at least ten minutes before touching live sections of the equipment
or undoing connections (e.g., contacts, screwed connections). Capacitors can store dangerous voltages for long
periods of time after power has been switched off. To be safe, measure the contact points with a meter before
touching.
Be alert to the potential for personal injury. Follow the recommended precautions and safe operating practices
included with the alert symbols. Safety notices in this manual provide important information. Read and be familiar
with these instructions before attempting installation, operation, or maintenance. The purpose of this section is to
alert users to possible safety hazards associated with this equipment and the precautions that need to be taken to
reduce the risk of personal injury and damage to the equipment.
Failure to observe these precautions could result in serious bodily injury, damage to the equipment,or operational
difficulty.
7
STM23 Hardware Manual
920-0021F
2/14/2012