Atlona Fiber - Manual (Page 11)

Toll free: 1-877-536-3976
Local: 1-408-962-0515 atlona.com
11
ATLONA PRODUCT REGISTRATION
Thank you for purchasing this Atlona product — we hope you’ll enjoy it.
We also hope that you’ll take a few moments to register your new purchase. Registration creates an ownership
updates.
At Atlona, we respect and protect your privacy and assure you that your registration information is completely
secure. Of course, Atlona product registration is totally voluntary and failure to register will not diminish your limited war-
ranty rights.
To register go to www.atlona.com/registration
SERIAL DATA AND IR DATA INTERFACE
The transmitter transmits two channels of unbalanced data signals. Follow the procedures for install-
ing data terminal devices.
1. Label and connect one RS232 cable to the user’s RS-232 device.
2. Connect the other end of this cable to the front panel data terminal block connector (as displayed
on the picture above)
The transmitter transmits one (1) channel of IR data signal. Use the following steps for IR connection.
1. For the source side, (transmitter unit) connect IR Emitter cable to the IR connection.
2. For the monitor side (receiver unit), connect IR pick-up cable to the IR connection.