Atlona ATHDSync V3 - Manual (Page 5)

Mode 0: 1080p - 2Ch audio
*3D and multichannel audio will not work in this mode.*
Mode 1: 1080p - Multichannel audio
*3D will not work in this mode.*
Mode 2: 1080p - 2Ch audio - 3D
*Multichannel audio will not pass in this mode.*
Mode 3: 1080p - Multichannel audio - 3D
*The highest resolution the display and source are capable of will pass in this mode.*
Mode 4: 1080p - Dolby Digital audio - 3D
*Only Dobly Digital and 2Ch audio will pass in this mode.*
Mode 5: 1080i or 720p - 2Ch audio
*Multichannel audio will not pass in this mode.*
Mode 6: EDID learning
*Learn the EDID of the display while in this mode. The EDID learn is non-volatile*
Mode 7: Software mode
*Read, save, and analyze EDID or update firmware with the included software in this mode*
1. Connect the HDSync display HDMI port to the display’s HDMI port
2. Plug in the 5V DC power supply to the HDSync and wall
3. Turn on the display
4. Turn the HDSync rotary to mode 6.
*Status LED will blink while learning the EDID*
5. When the LED goes off, the EDID learn is complete. Leave the EDID Rotary on mode 6.
**To relearn or learn a different EDID, turn the Rotary from mode 6 clockwise until it reaches mode 6 once
more. Repeat the above steps.**
Read, save, or analyze EDID and update firmware from your computer using the included software.
Easily troubleshoot compatibility issues or verify what a device is capable of.
1. Connect a 9pin to 9pin cable from the HDSync to your PC.
(a 9pin to USB cable may also be used)
2. Turn on your PC and the HDSync.
3. Insert the included software into your computer’s disc drive.
4. Open the software file “HDMI EDID Recorder”
(see picture A on top of page 6)
5
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
EDID
Software
Modes
Learn
Set Up