Panel description, Front panel ir – Atlona AT H2H V2 User Manual
Page 4
4
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
The IR receiver window can sometimes pick up stray reflected IR commands causing loss of
functionality. To disable the front panel, see directions below:
Panel Description
Front Panel
IR
AT-H2H-88M
AT-H2H-88M
DC 24V
ENTER
POWER
EDID
MEMORY
ALL
DEFAULT
CANCEL
FUNCTION
1
2
3
5
6
7
8
4
COAXIAL OUT
HDMI OUT
HDMI IN
RS-232
ETHERNET
IR IN
FIRMWARE
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1. IR Receiver Window - Receives the signal from the included IR remote control or a 3rd party
controler.
2. Power Button - Cycles the power between On (blue backlight) or Standby (red backlight) mode.
3. Enter Button - Use to view current status for inputs and outputs or to confirm a command.
4. Number buttons - Use these buttons to select input and output paths or use with the function
button to change matrix settings.
5. Function Button - Select for command options. (blue backlight when selected)
A.
Default: Mirrors all inputs to corresponding outputs. (i.e. 1 to 1, 2 to 2, 3 to 3, etc.)
B.
All: Save a single input to all the outputs with this function.
C. Memory: Save/load the current input and output route to memory.
D. EDID: Save/Load EDIDs to individual inputs.
Note: Default setting for EDID is the highest common HD resolution of all connected
devices. (i.e. if you have resolutions ranging 720p, 1080i, and 1080p then 720p would be
the default resolution for all connected displays.)
6. Cancel Button - Within the functions menu use to go back one screen or to the home screen.
Note: You cannot power off or change functions unless you go to the home screen.
5
2
1
3
4
6
A
B
C
D
Hold for
5 seconds
--->
--->
--->
AT-H2H-XXM
Select Input Number
home screen
Select Function Option
--------------------
--->
Select IR 1:On 2: Off
Current: On/Off
Select IR 1: On 2: Off
Current On
Select IR 1: On 2: Off
Current off
--->
--->
--->
--->
--->
--->
Feedback=
”IR On Selected”
Feedback=
”IR Off Selected”