Audio Solutions AS-CM3260 - Manual (Page 10)

10
SteP 8
NOTE: Angle/Height adjustment should be done by at least two people.
•
(A) While another person is holding the television assembly, loosen the two screws on either side of
the mounting plate and tilt the television up to 5 degrees back or 15 degrees forward. Tighten the
screws when the desired angle is achieved.
• (B) To adjust the height, remove the screws to separate the two sections of pole and slide the pole
up/down until you reach an acceptable height that corresponds with screw holes. Replace the screws
and tighten to secure. A second person (or two) must hold the television during adjustment to avoid
damaging the television or mount. Use caution when raising or lowering to avoid damaging the wires
inside the pole. WHILE THE SCREWS ARE LOOSE, THE BOTTOM POLE COULD SLIDE OUT.
B
A
Figure 8 - Adjust Angle/Height
INStAllAtION