BIXOLON SRP-350IIOBE - Manual (Page 11)

Rev. 1.03 - 11 -
SRP-350IIOBEi
1-3 Connecting the Drawer
※ WARNING
Use a drawer that matches the printer specification. Using an improper drawer may
damage the drawer as well as the printer.
※ CAUTION
Do not connect a telephone line to the drawer kick-out connector; otherwise the printer and
the telephone line may be damaged.
Plug the drawer cable into the drawer kick-out connector on the back of the printer next to
the power supply connector.
Pin No. Signal name Direction
1 Frame GND -
2 Drawer Kick-Out Driver Signal #1 Output
3 Drawer Open / Close Signal Input
4 +24V -
5 Drawer Kick-Out Driver Signal #2 Output
6 Signal GND -
1-4 Setting the Dip Switches
• DIP Switch 1
SW
Function ON OFF Default
1-1 Reserved - - OFF
1-2 Reserved - - OFF
1-3 Reserved - - OFF
1-4 Reserved - - OFF
1-5 Auto Cutter Disable Enable OFF
1-6 Internal Bell Control Disable Enable OFF
1-7 Near End Sensor Disable Enable OFF
1-8 MFi Mode Selection iOS Normal ON