Brennenstuhl Brobusta All-round Lamp RL E27 IP54 5m H07RN-F 3G1,5 max.60W - Manual (Page 5)

5
Brobusta RL Instruction Manual
Technical specifications
200 mm
39
0
m
m
Operating manual: 220-240 V~ 50/60 Hz
Number of power sockets : 2
Total socket capacity: 3500 W
Lamp: E 27, max. 60 W
Connecting cable: 5 m H07RN-F 3G1,5
Protection class: I
Degree of protection:
IP 54
(protected against dust and water)
Safety instructions
Check both lamp and connection cable for possible damage before every use. Never use
the lamp if you discover any damage whatsoever. Damaged cables must be replaced at
once by the manufacturer, its service representative, or a similar specialist.
Lamp repairs must be carried out by an electrically skilled person.
In case of non-observance, there is danger to life due to electric strike!
Energy-saving lamps contain small amounts of mercury. In case the lamp gets damaged it
is recommended to air for a few minutes and to leave the room. Kindly also observe the
other instructions in the Service / FAQs area on our homepage.
The lamp must be unplugged before the beacon dome is removed.
The lamp heats up during operation. Do not touch the lamp when it is on.
Let the lamp cool down sufficiently before you change it.
Never use a lamp with a higher capacity than that indicated under section “Technical
Specifications” in this manual or on the lamp itself!
Fire hazard: Do not cover the lamp with any objects. Extensive heat may cause a fire!
If the beacon cover is defective or broken it must be replaced immediately .
Keep children away from the working lamp. Children are unable to evaluate the risks
caused by electricity.
Operation
Insert or change lamp
Make sure that the lamp is not connected to the mains voltage. Remove the safety screw
(Fig. 1a). The beacon cover can now be removed by turning it counter-clockwise (Fig. 1b).
Remove the old lamp, if necessary, and screw the new lamp into the lamp socket. Use a
clean, lint-free cloth when changing energy-saving lamps and avoid directly touch the
glass with your fingers as this might influence the service life of the energy-saving lamp.
The lamp must be in correspondence with the information in section “Technical Specifica-
tions” of this manual or on the lamp itself. Assemble the lamp now in reverse order.
We recommend using an energy-saving lamp from our product range.
013112 Brobusta RL 23.05.14 08:34 Seite 5