CP Electronics VITP-IR - Manual (Page 6)

6
USING AS A DIMMER

When the lighting is switched, the light level can be manually adjusted on a temporary
basis. Set the level using the LUX UP and LUX DOWN buttons.

To revert to maintained illuminance press the CANCEL button.
SETTING THE LUX LEVEL - DIMMING APPLICATIONS
The maintained illuminance target lux level can be set as above or using the handset.

To set the level press the SET button.

Then slowly press the LUX UP or LUX DOWN buttons repeatedly to obtain the
desired lux level.

After 2 minutes without pressing the buttons, the unit will revert to normal operation.
This can also be achieved sooner by pressing the CANCEL button.
SETTING THE SWITCH ON LEVEL - DIMMING APPLICATIONS
This is the light output that will be set when the unit first switches on.

Press the LUX UP and LUX DOWN buttons to reach the desired switch on level (do
not press the SET button first).

Press the ON button within 10 seconds to memorise the level as the switch on level.
OVERRIDING ON AND OFF

To turn off lighting permanently press the OFF button.

To return to automatic operation press the CANCEL button.

To turn on lighting permanently press the ON button.

To return to automatic operation press the CANCEL button.

In both override modes the red LED behind the detector lens will flash at regular
intervals to indicate that the detector has been overridden.
4. Programming
Using the User Handset (Part No. UHS)